Air source heat pump heating to energy-saving and efficient advantages of the user's needs, and in the purchase, installation, use of attention to a few details, the principle of operation is very energy efficient air energy heat pump, energy-saving effect can also be a higher level.
When choosing, inverter air source is more energy efficient than standard air source
There are two types of air source heating heat pumps: standard and inverter. Standard air source heat pump can only run at one frequency during operation, and will stop when the temperature reaches the set temperature, and will restart after the temperature drops to the zone, resulting in frequent shutdowns and restarts a large amount of power consumption since. The inverter air source will run at a high frequency to heat quickly, after reaching the temperature to low-frequency energy-saving mode, to a small energy consumption to maintain the operating state, will not directly shut down, which is conducive to prolonging the life of the compressor and reduce energy consumption.
When installing, take care to insulate pipes and walls well
The insulation capacity of the pipes and the house affects the energy consumption of the air source when it is running. If the pipes are not insulated, they tend to lose heat during the transport of hot water; and if the walls are not insulated, the temperature drops quickly after heating. This will lead to the air source heat pump needs to run more frequently to raise the temperature, which will then increase energy consumption. On the contrary, such as piping and wall insulation, heat loss is not easy, the air source heat pump operation of the power consumption will also have a corresponding reduction.
When using it, don't start and stop as often as you would with other appliances
The general habit of using electrical appliances is to use when on, not use to close, but the air source heating heat pump is not suitable for this set of use. Because the air source heating heat pump in the warming phase of the energy consumption is the largest in the entire operation process, if the heating and then immediately shut down, the overall room temperature will drop very quickly, and so cold and then turn on, and then let the equipment to repeat the process of the largest energy consumption, will consume a lot of electricity. Unless you go out for a long time, such as business trips, travelling, etc., as long as there are people in the house, it is not recommended to turn off the unit when it warms up and turn it on again when it gets cold.
Do a good job of details, many things can become better, the use of air source is also the same, pay attention to details can make the energy saving effect upgrade. As one of the top ten brands of air source, Juteng focus on stainless steel air source for 24 years, also focus on product details, the introduction of -35 ℃ ultra-low temperature inverter stainless steel air source heating unit, the appearance of the whole material stainless steel is more durable, the internal core system accessories with more high-quality materials, inside and outside the details of the pull full, high standards of quality, the effect of the guaranteed, the user is highly praised by the air source heating products.
